Dmg Silagum Putty With Light Body Kit

Interactions

• Avoid contact with retraction solutions, because in some instances residues of retraction solutions can increase the setting time.
• Never allow the impression to come into contact with organic solvents or liquids containing solvents as this may result in a swelling of the material and may therefore lead to inaccuracies in the cast
• Avoid contact between the impression material and latex gloves because these inhibit the setting process. In the event of prior contact between the hands and latex gloves, wash hands thoroughly. It is recommended that PVC or PE based gloves be used
• Do not mix Silagum with condensation curing silicone or polyether impression materials.

Instructions for use

• Silagum-Putty can be used in all common impression trays. In order to improve the adhesion of the material to metal or plastic trays, a tray adhesive can be applied (e.g. DMG Tray Adhesive)
• In order to ensure that the two impression materials bond securely with each other, a period of no more than 30 min may pass between the pre-impression and correction impression. Alternatively, it is possible to employ the double mixing impression technique

Recommended use

• Double-mix impressions
• Fill the tray with Silagum-Putty.
• Syringe the preparations with Silagum-Light.
• Position the filled impression tray in the mouth and allow the impression to form
• Remove the impression from the mouth once the setting time has ended.

Note: The filling of the impression tray and syringing should be completed at the same time, because the higher temperature in the mouth leads to a quicker setting of the syringed material compared to the tray material

Correction impression

• Fill the tray with Silagum-Putty and insert into the mouth within the working time. Maintain this position in accordance with the recommended intraoral setting time.
• Remove the impression from the mouth once the setting time has ended.
• Cut generous drainage channels into the preimpression for the wash and remove imperfections.
• After repositioning, thoroughly rinse the impression with water and dry.
• Apply Silagum-Light around the preparation and on the pre-impression
• Position the tray in the mouth within the working time and initially exert brief pressure
• Remove the impression from the mouth once the setting time has ended.

Removal of the impression

• Remove the impression parallel to the longitudinal axis of the prepared teeth.

Cleaning and disinfection of the final impression

• Only disinfect the final impression using dipping solutions. DMG recommends the use of a 2 % glutaraldehyde solution.
• Please ensure that the disinfectant used is indicated for use with addition curing silicone impression materials
• Follow the instructions of the disinfectant solution’s manufacturer precisely
• Leave the final impression to dry and store until casting

Storage and shelf-life

• Store at room temperature (15 – 25 °C/59 – 77 °F) in a dry place
• Do not store in the fridge or freezer
• Protect against exposure to direct sunlight
• After the application, leave the used tip on the cartridge to cap unused material
• Close the can again immediately after use
• Do not use after the expiration date.