STEP 1: Select and/or prepare a suitable tray. Prior to application of Tray Adhesive, trial fit tray for proper fit and extension.
STEP 2: After proper fit is assured, rinse and thoroughly dry tray.
STEP 3: Brush a thin layer of Tray Adhesive onto the tray surfaces that will be covered with impression material and allow to air dry for at least five minutes, but no more than 30 minutes. Repeat application if greater than 30 minutes have elapsed.
Technique Tip: Avoid placement of excess adhesive onto tray surfaces. Retention will NOT be enhanced and may be compromised by placement of a thicker layer of tray adhesive onto tray surfaces.
STEP 4: Mix and place desired tray viscosity impression material directly into coated impression tray as per selected impression material directions.